Stages · Built in
Stationary stages Built in, and raised by gas spring – no power needed
Quellennachweis: MM Video-Fotowerbung Michael Meschede Kaufungen
A stage that fits the interior and does not look like a mobile stage – even in halls that are not rectangular. With Servo Stage platforms, you adjust the height from above with a key. Gas springs take part of the weight, and you need no power for it.
- Heightby gas spring, no power
- Installationcan sink flush into the floor
- Load750 kg/m²
- Shapefitted to the room
Benefits
No basement, no carrying The stage stays where it is needed
Change the height, not the set-up
The Servo Stage stays level with the floor, rises in steps or becomes a raised stage. It is adjusted from above with the adjusting key.
No power, no controls
Gas springs support the lifting, like power steering in a car. No power connection, no control system.
No basement, no transport
The stage stays in its place. Nobody carries platforms out of the store room, nobody searches for legs and clamps.
Fits any floor plan
Not every hall is rectangular. Custom shapes, steps and full cladding make the stage part of the building.
The same floor as the hall
Decks to your specification: parquet, linoleum, wood or the floor finish already in the room.
Tested and accepted
Designed for 750 kg/m². Design, structural calculations, production and assembly come from one manufacturer.
Types
Which built-in stage fits? Three ways to a fixed stage
| Type | Height | Adjustment | Suitable for |
|---|---|---|---|
| Servo Stage | locking positions up to 100 cm | from above with a key, gas springs | halls, restaurants, congress and civic halls |
| Servo Stage 1500 | locking positions up to 150 cm | from above with a key, gas springs | stepped and retractable stages and grandstands |
| SoloDrive One motor platform | stepless | at the push of a button, stage layouts can be saved | frequent changeovers, fully variable stage areas |
| Fixed platform stage | fixed height | none | stages with full cladding, also in custom shapes |
For permanent halls we also build stages on steel substructures, with several levels if required.
How the installation works
One contact person from the floor pit to the final inspection
Plan it in early
For a new building or renovation, we discuss the floor pit, stage shape and floor finish during the planning phase. For the Servo Stage, a pit of approx. 20 cm is enough.
Design
Our design department draws the stage to fit the building – with curves, steps and cut-outs.
Produce
Platforms, frames and cladding are made in our own factory in Mettmann, Germany.
Install and inspect
Our team installs the stage. The acceptance inspection by an expert inspector and a structural engineer also comes from our company.
Reference
Volkshaus Jena Stage sets at the push of a button, not from the basement
Before the renovation, the stage sets were carried up from the basement several times a week. The goals were short changeover times, less physical strain on the staff and fast stage design.
- SoloDrive One motor platforms, scenes saved on a touch panel
- 110 m²
- Servo Stage with parquet
- 50 m²
- VolkshausJenaAcceptance inspection in-house by an expert inspector and a structural engineer
- WaldbühneBerlinStage area
In use
Stepped, clad, in the studio Stationary stages in use
Accessories
Matching accessories for your built-in stage
Downloads Brochures on Servo Stage and SoloDrive One
For planners
Questions
Pit, power, shape, operation Questions about stationary stages
How deep must the pit be for a stage that sinks into the floor?
For the Servo Stage, approx. 20 cm. Aluminium edge profiles give a clean edge to the surrounding floor. Additional floor finishes increase the installation depth.
Do we need power to adjust the height?
Not with the Servo Stage: gas springs support the lifting, and it is adjusted from above with the key. If you change over often and want to save stage layouts, choose the SoloDrive One motor platform.
Our hall is not rectangular. Is that possible?
Yes. We make custom shapes, curves and steps to fit the building. With full cladding and decks to your specification, the stage looks like part of the room.
Who may adjust the platforms?
The Servo Stage should only be operated by trained staff. Operation is simple: unlock, lift, lock in place, check.
Planning a new building or renovation? Talk to us early about the stage
Send us the floor plan, the stage area and the heights you need – we recommend the type and the installation depth.
Stationary stages
by gas spring, no powerby gas spring, no power · can sink flush into the floor